2008-01-17, 9:46AM CST
GENERAL FUNCTION
PERFORM DAILY ACTIVITIES OF RECEIVING INSPECTIONS TO INSURE QUALITY AND ACCURACY OF ALL MATERIALS AND PARTS RECEIVED AND COMPLIANCE OF CUSTOMER REQUIREMENTS.
TYPICAL DUTIES
READS SHOP ROUTERS, BLUE PRINTS AND OTHER WORK INSTRUCTIONS TO DETERMINE DAILY REQUIREMENTS. PAYS CAREFUL ATTENTION TO CUSTOMER SPECIFIC REQUIREMENTS, MATERIALS AND/OR SPECIAL INSTRUCTIONS. CONDUCTS VISUAL AND DIMENSIONAL INSPECTIONS OF ALL INCOMING MATERIAL AND PARTS FOR CONFORMANCE TO PURCHASE ORDERS, QUANTITIES AND SPECIAL REQUIREMENTS.
CHECK MTR’S PER CUSTOMER SPECIFICATIONS AND DIMENSIONAL LOGS. INSPECT DIMENSIONS AS REQUIRED.
WRITES NCR’S IF NECESSARY AND INSURES REJECTED MATERIALS AND/OR PARTS ARE PROPERLY IDENTIFIED AND MOVED TO THE REJECTED MATERIAL (HOLD) AREA.
REFER UNUSUAL INSPECTION PROBLEMS TO QC SUPERVISOR.
INSURE ALL REQUIRED DOCUMENTATION IS PROVIDED AS JOB MOVES THROUGH DIFFERENT PROCESSES IN THE SHOP.
VERIFY AND INSPECT ANY REQUIRED COATINGS AND STENCILING.
ASSIST IN STAGING INCOMING MATERIALS AND PARTS FOR JOB PROCESSING.
FORWARDS ROUTER PACKAGE TO QC SUPERVISOR FOR REVIEW.
MAY BE REQUIRED TO PERFORM OTHER BASIC QA FUNCTIONS SUCH AS ASSIGNING TRACEABILITY NUMBERS TO INCOMING MATERIAL, REVIEW INCOMING PAPERWORK FOR QUALITY AND COMPLETENESS AND OTHER AS ASSIGNED BY QC SUPERVISOR OR Q&S MANAGER.
PRINCIPLE RESPONSIBILITIES AND AUTHORITY
OBJECTIVES, PRIORITIES AND DEADLINES ARE DEFINED. ASSISTANCE IS GIVEN WITH UNUSUAL SITUATIONS THAT DO NOT HAVE CLEAR OBJECTIVES. PLANS AND CARRIES OUT SUCCESSIVE STEPS AND RESOLVES PROBLEMS AND DEVIATIONS IN ACCORDANCE WITH INSTRUCTIONS, POLICIES, AND ACCEPTED PRACTICES. THE SUPERVISOR REVIEWS PROGRESS VERSUS DETAILED CHECK FOR TECHNICAL ADEQUACY AND CONFORMANCE WITH PRACTICE AND POLICY.
REQUIRED KNOWLEDGE/QUALIFICATIONS/EDUCATION
MUST HAVE A CLEAR UNDERSTANDING OF BASIC MATH AND HAVE THE ABILITY TO READ, WRITE AND COMPREHEND ENGLISH (ROUTERS, REPORTS, BLUE PRINTS, QUALITY MANUAL, SAFETY & OPERATIONAL INSTRUCTIONS). HIGH SCHOOL DIPLOMA PREFERRED.
TYPICALLY HAS THREE TO FIVE YEARS RELATED EXPERIENCE WITH FAMILIARITY OF THE MATERIALS USED IN THE PROCESS OF WELDING. PREFER AT LEAST TWO YEARS EXPERIENCE AS A WELDER WITH PROVEN ABILITY TO MEET OR EXCEED PRODUCTION AND QUALITY TARGETS UNDER GENERAL SUPERVISION.
MUST POSSESS THE ABILITY TO LEARN THE MORE ADVANCED INSPECTOR SKILLS AND ABILITY TO USE MEASURING DEVICES SUCH AS MICROMETERS AND CALIPERS.
MUST BE ABLE TO RECOGNIZE AND MAKE ALL ADJUSTMENTS ON WELDING EQUIPMENT.
MUST BE FAMILIAR WITH QUALITY SYSTEMS.
MUST BE ABLE TO USE MEASUREMENT EQUIPMENT AND MUST BE ABLE TO INSPECT PARTS ACCORDING TO DEFINED PROCEDURES.
MUST DEMONSTRATE ABILITY TO COMPLETE REQUIRED DOCUMENTATION IN AN ACCURATE AND TIMELY MANNER.
MUST DEMONSTRATE A GOOD WORK ETHIC AND OVERALL WILLINGNESS TO LEARN.
MUST UNDERSTAND AND FOLLOW ALL SAFETY POLICIES AND APPLY GOOD SAFETY PRACTICES WHILE WORKING.
MUST HAVE ABILITY TO OPERATE A FORKLIFT, OVERHEAD CRANE, HOISTS, HAND TOOLS, POWER TOOLS, TAPE MEASURE, MEASUREMENT TOOLS AND SCALES.
- Location: North Houston (249 area)
- Compensation: $12.00 to $16.00 per hour DOE
- Principals only. Recruiters, please don't contact this job poster.
- Please, no phone calls about this job!
- Please do not contact job poster about other services, products or commercial interests.
PostingID: 542096271
|
It is ok to contact this poster with commercial interests.
4 hits
|
